06 Aug 2014

How do I cut these sheets?

The sheets are very easy to cut. One way which works well is with a box cutter knife with the blade extended. Cut with the geotextile up to reduce shaggy edges if the geotextile is on the far side. Fine tooth saws and power saws are fine too, as are serrated bread knives! They are very easy to cut, the plastic in the matrix is only 1.2mm thick plastic. Each sheet is made of a number of smaller grids welded together. The join double thickness so with a box cutter you have to gnaw the knife a little, but it is quick and simple.

06 Aug 2014

Can i use shells instead of pebbles in Natural Paving?

You can use crushed shell, and you will have the control of any weeds below
the mat, they will not be able to get through the geotextile, but please be
aware that the shell is weak. Under foot traffic it will gradually crush and
compact into the Natural Paving grid in the trafficked area. This will
result in the surface at the top of the grid becoming flat and compact, and
the benefits of the Natural Paving will be compromised.

In contrast, when you use 8 to 14mm pebbles, the stones that overlay the
grid are stabilised because they sit in what are effectively ‘nests’ formed
by the gaps between the pebbles below. Those pebbles are held in place by
the Natural Paving grid. The grid is covered in pebbles and is hidden by the
next two layers of pebbles which is the recommended coverage. The resulting
surface is made up of pebbles all stable because they are nested like eggs
in a crate. The surface looks completely natural but is so stable that even
stiletto heels or the skinny tyres of a racing bicycle traverse it without
displacing the pebbles, and the surface stable.

With shells, you lose all the stabilising influence of shells on top sitting
in ‘nests’ if the shells are crushed underfoot, and compacted into the grid.
If you sprinkle fresh shells on top it would be like sprinkling shells on a
hard flat surface. The time it takes for the shells to crush and compact
depends on the amount of traffic, but, for a while, Natural Paving will
stabilise shells.

If it is the colour you want, then you could consider using white quartz
pebbles which are smooth and nice to walk on, but expensive. You could also
consider using lime chips that are the colour of shells and economical, but
not so nice to walk on..

If you really want the shell finish you could use Natural Paving to hold the
shells in place, but accept that in the longer term maintenance will be
required if the shells become crushed and compacted. This would entail
lifting each mat, tipping out the crushed shells and filling the mats with
fresh shells.

06 Aug 2014

Which edging should I use for my driveway?

Thanks for your fantastic question. Edging is a very important aspect of Natural Paving installation system. The minimum edging we recommend is 100 x 25 rough sawn H4 treated pine for Clutha-garden grade, and 100 x 75 rough sawn H4 treated pine posts for Waiau-Car grade. It is a more substantial lump of wood because cars should be able to run over it without damage. Both these sizes are commonly available and economical. The edging is placed at a level 20mm above the top of the plastic grid. It is there to keep the stones at the edge from rolling off. There should be 15 to 20mm depth of stones covering the grid, not more and not less.

06 Aug 2014

What is the maximum slope I can use Natural Paving?

Thanks for your question.

The maximum recommended slopes for Natural Paving:

CLUTA-Garden grade

Max slope with:
Round pebbles 1 in 5 or 11 Degrees
Crushed gravel 1 in 4 or 14 Degrees

WAIAU-Car grade

Max slope with:
Round pebbles 1 in 6 or 9.5 degrees
Crushed gravel 1 in 5 or 11 degrees